BIRO Mini-32 Service Manual

PTCTMINI-32299-7-05-2

PARTS LOCATION6

OPERATIONROTATING GRINDING AUGER & ROTATINGMIXING PADDLETO AVOID SERIOUS PERSONAL INJURYONLY Properly Trained Personnel Should Use This Equipment.

CLEANINGBEFORE CLEANING OR SERVICINGALWAYS Turn Off, Unplug Machine From Power Source and Perform Lockout/Tagout Procedureto This Machine Before Clean

DISASSEMBLY INSTRUCTIONSPADDLE REMOVAL:Remove mixing paddle by first locating and lifting up on the hopper lock down clamps releas-ing them from the h

MAINTENANCEROTATING GRINDING AUGER &ROTATING MIXING PADDLETO AVOID SERIOUS PERSONAL INJURYALWAYS Turn Off, Unplug From Power Source and Perform Lo

MOTOR DRIVE COVERANDHOPPER COVER11Fig. Item No. Description9 50024 Auger drive shaft seal26 63021 Nylon bearing cover50 63085 Hood, motor & drive

12Fig. Item No. Description1 15026-02 Double roller chain 49"2 15029 Double chain master link3 20050-10 #40 Roller chain4 20050-01 #40 Chain mast

TRANSMISSION MOUNTING ASSEMBLY13Fig. Item No. Description5 20665 Key ¼´¼´118SS6 20665-01 Key ¼´¼´1¾ SS8 30315 O-Ring 1.25 I.D.10 50029 Washer – brass1

BOWL & WORM ASSEMBLY14Fig. Item No. Description23 63017 Bowl mounting stud, 2 required60 54278-CTN Auger assembly60A HK48 Knife drive pin60B 54278

FASTENERS & LOCATIONS15Base Plate (63005) to Cart Assembly (63055)4 ea. HHS088S38-16´2¼4 ea. LW25S38heavy4 ea. HN25S38-16 heavy (with loctite)Fram

MINI-32 SCHEMATICfor 208-230/460 Volts, Three Phase, 60 Cyclewith Elobau Magnetic Safety Switches16

OPTIONAL PNEUMATIC FOOTSWITCH17

SAFETY LABEL LOCATIONS18

OPERATOR’S SIGNATURE PAGEWARNINGREAD AND UNDERSTAND THIS ENTIREMANUAL BEFORE SIGNING BELOWMY SIGNATURE ATTESTS THAT I HAVE COMPLETELY READ AND UNDERST

LIMITED WARRANTY:WARRANTY: The Biro Manufacturing Company warrants that the BIRO MINI-32 Grinder will befree from defects in material and workmanship

TABLE OF CONTENTSPageSAFETY INSTRUCTIONS ... 1SAFETY INSTRUCTIONS ...

— OPERATOR'S NOTES —

BIRO’s products are designed to process food products safely and efficiently. Unless the oper-ator is properly trained and supervised, however, there

SAFETY TIPSROTATING GRINDING AUGER &ROTATING MIXING PADDLESTO AVOID SERIOUS PERSONAL INJURYNEVER Touch This Machine without Training and Authoriza

INSTALLATIONTO AVOID SERIOUS PERSONAL INJURY, PROPERLY INSTALLEQUIPMENT IN ADEQUATE WORK AREAALWAYS Use Qualified Technician and Electrician for Insta

MOTOR WIRING AND ELECTRICAL REQUIREMENTS1. Interchange of motor current is made in motor outlet box. Leads are properly marked. Changing instructionsa

10. The start stop switch and the grind engage lever are located on the right side of the machine when facing thegrinding bowl. The start stop switch